All Insights
Application Engineering · 3 min read

How to Size an Electric Powertrain for a Commercial Vehicle

A practical starting point for defining torque, speed, voltage and continuous-duty requirements.

Powertrain selection starts with the vehicle and its duty cycle—not the motor catalogue. A vehicle that climbs grades with a payload and a vehicle that cruises on level roads can demand very different torque and thermal performance.

01

Start with the vehicle

Define gross vehicle mass, loaded tire radius, target speed, gradeability, acceleration expectations and the worst-case duty cycle. Separate normal operation from short-duration overloads.

These inputs let you estimate the wheel tractive effort needed for grade climbing, rolling resistance and acceleration. Aerodynamic drag becomes increasingly important at higher speeds.

02

Translate wheel requirements to the motor shaft

The gearbox and final drive translate wheel torque and speed to motor operating points. Include transmission efficiency rather than treating gearbox output torque as wheel torque.

Check the entire torque–speed envelope: continuous torque, short-duration peak torque, base speed, maximum mechanical speed and cooling limitations.

03

Evaluate the electrical system

Confirm nominal and usable DC-bus voltage, battery current limits, regeneration acceptance, motor-controller current capability and communication interfaces. Peak motor and controller ratings must have defined durations and thermal conditions.

The result should be a system-level requirements sheet, followed by simulations, prototype testing and vehicle validation before a production decision.

Engineering guidance only. Select and validate components against the actual application and approved product documentation.

Discuss an Application